Use brick machine equipment can be said to be us into an era of mechanized brick, which is an important sign of the times. In particular, this brick-making process, compared to traditional brick-making process more simple, the entire production process, eliminating the traditional firing step in fully mechanized production, we only need to table a reasonable operation and control, it is possible to produce a very high number of unburned. Secondly Shandong wins Asia Machinery brick machine has a very characteristic, that is, simple appearance and operation, suitable for use brick now. Mold is an essential brick machine production process, the production needs of different brick mold is not the same, then how to replace the brick machine mold it:

   Step one: Replace when unburned block brick mold, you should adjust the hydraulic system to manual operation status, and then lift hydraulic machine.

   Step two: first raise the limit on the mold, the supremacy of the border raise the limit, the lower mold operating units at the forward limit.

   The third step: closing the upper and lower molds manually, including borders, release the mold and borders tight bolts on the first die to improve the channel ceiling rose, rose rose borders to improve the shelf limit will remain at the border on the mold and the lower mold , to insist clamping state.

   Step four: the lower mold operating units retreated to retreat limit, you can take away the original mold, the mold ready to pay the full replacement put humble mode operation table.

   Step Five: lower die sets to advance to the forward operating limit position, began to adjust the orientation, the upper die down slowly, carefully adjusted and aligned with the upper and lower mold frame mounting hole position after parting fixed. Lower limit switch position near to the border on the adjustment, adjust the upper die and lower position. The upper die, borders filed. Check the condition of the lower die strainer, how damaged should be replaced.

   Step Six: Quantitative conditioning after feeding the height and position to determine the applicable position.

   Step Seven: conditioning pallet rack and the relative height of the mold to the proper orientation, ensuring that there are 0.5-1mm gap between the screws tight set of goods and pallets.

   Shandong Sheng Machinery Co., Ltd. has been dedicated sub-cement products machinery research and development, production and sales, with advanced equipment, superb technology and two years of professional experience, the company has always been at the forefront of research and development center block making machine market development , watching the advanced technology at home and abroad, to develop products for the investment needs of different users, there are block making machine, hydraulic tile machine, cement pipe machine, blender, hanging roller machine, wire rod machine equipment. Currently has 19 branch offices and six foreign countries (Nigeria, Tanzania, Algeria, Kenya, Mozambique, Ethiopia) and exported to more than 100 countries and regions.