Shandong Shengya Machinery Co., Ltd. specializing in the production of various types of brick, brick machine, brick machine, hollow brick, pavement brick and other equipment of the old brick factory.
     Use tile machine's some things we should pay attention to:
1, before using the new tile machine should always regulator can not be adjusted to the motor suffocated or labored too large. First turnover board put to concave mold bottom, then start the motor, the lever under pressure mold under pressure to observe the degree of damping blocks should be 2-3mm below the pressure is too large, the adjustment should be counter-clockwise under the pressure valve, such as Under pressure damping block is too small, you should adjust under the pressure valve clockwise until transferred to the appropriate travel date, after debugging qualified, on the plane and then feed hopper feed plate bracket raised concave mold with flat, debugging qualified after Ministries screw detention, to see whether you can scrape material above the lower mold.
2, when debugging a brick, vibrators vibration force found insufficient, we should first check whether the ram cylinder pressure is too high, as too should adjust counterclockwise line relief valve on the cylinder until the brick has strength as well, such as when the ejector, because the head pressure is too low, it can not locate causes a tile loose brick should be clockwise adjustment relief valve on the cylinder lines, or, at the same time lift the mold concave mold light Light move on punch wrench, so that the upper ram cylinder to maintain a certain pressure can be maintained in the die does not rise along with the brick mold, thereby reducing the breakage rate of brick.
3. The regulator failure, should advance check your pressure regulator spring is damaged, if damaged should be replaced.
4, cylinder leakage is found, it is the loss of the cylinder seals sealing effect, replace the corresponding type seals. ʱ??
     Shandong Shengya Machinery Co., Ltd. has been committed cement products machinery development, production and sales, with advanced equipment, superb technical expertise and two decades of experience, the company has always been at the forefront of research and development center block molding machine market development , concerned about the advanced technology at home and abroad, to develop products for different investment needs of users, mainly block making machine, hydraulic tile machine, cement pipe machine, mixer, hanging roller machine, telephone poles machine equipment. At present the country with 19 offices and six overseas plants (Nigeria, Tanzania, Algeria, Kenya, Mozambique, Ethiopia) and exported to more than 100 countries and regions.