Shandong Shengya Machinery Co., Ltd. specializing in the production of various types of brick, brick machine, brick machine, hollow brick, pavement brick and other equipment of the old brick factory.
   Mianshaozhuanji hydraulic system may malfunction and troubleshooting - without oil suction pump, the system is not pressure how to do?

Symptom 1: The pump suction is not oil, no pressure system. (Hydraulic system noise situation, Remedy and this failure is basically the same.)
Symptoms showed above, the motor can be started, but no oil pump, the size of the pump is not pressure.
1-1 Cause: The mailbox of the hydraulic oil level is too low. In this case, the pump will run when the general noise.
1-1 Remedy: add hydraulic oil. Usually the hydraulic oil is added to the upper level gauge position, must not exceed the maximum level meter scale (avoiding oil too full, splashing, causing oil spills). When the hydraulic oil is below the minimum level gauge scale it is necessary to replenish the hydraulic oil.
1-2 Cause Failure: wrong direction of rotation of the motor.
1-2 Remedy: replace the steering motor, so that the direction of rotation of the pump motor rotates clockwise. (When installing, you must ensure that the pump and the motor axis the same.)
1-3 Cause Failure: pump suction pipe or the suction port leakage. (In this case, the pump generally have noise.)
1-3 Remedy: Check whether the suction pipe seal air leaks or suction port at the connection is broken.
1-4 Cause Failure: equipment downtime is too long, the oil is too low or too high a viscosity of the hydraulic oil.
1-4 Remedy: choose my company recommended by the label of hydraulic oil according to local climatic conditions. (In principle, the proposed anti-wear hydraulic oil with anti-foaming additives, anti-corrosion additives and other northern recommended use user viscosity number of 32 hydraulic oils, south user is recommended to use a viscosity of 46 anti-wear hydraulic oil, and to use the winter season based on temperature changes of different viscosity hydraulic oils. Different types of brands of hydraulic oil can not be mixed.) oil temperature is too low, the hydraulic oil should be first heated to over 10 degrees, and then further in the pump filling These fluids (shutdown time is too long, this procedure need to be turned on the pump.), to be pumping hydraulic oil after running for some time, until the oil temperature rose to 20 degrees, in the operation of the equipment, put into production.
1-5 Cause: Plum oil pump and the motor between the cushion for wear or damage. (In this case, the pump generally have noise.)
1-5 Remedy: Replace the plum cushion.
1-6 Fault Cause: Suction filter is clogged. (In this case, the pump generally have noise.)
1-6 Remedy: Clean or replace the oil filter. (Blockage is severe, use a plastic scrub brush.)
1-7 Fault Cause: Pump wear or damage. (In this case, the pump generally have noise.)
1-7 Remedy: Remove the oil pump repair or replacement.
    Shandong Shengya Machinery Co., Ltd. has been committed cement products machinery development, production and sale of advanced equipment, superb technical expertise and two decades of experience, the company has always been at the forefront of research and development center block molding machine market development Follow the advanced technology at home and abroad, to develop products for different investment needs of users, mainly block making machine, hydraulic tile machine, cement pipe machine, mixer, hanging roller machine, telephone poles machine equipment. At present the country with 19 offices and six overseas plants (Nigeria, Tanzania, Algeria, Kenya, Mozambique, Ethiopia) and exported more than 100 countries and regions.