Shandong Shengya Machinery Co., Ltd. specializing in the production of various types of brick, brick machine, brick machine, hollow brick, pavement brick and other equipment of the old brick factory.
Crushing machine use and maintenance of knowledge:
Preparing a starter before
1, carefully check the bearing lubrication is good, whether the connection brackets have adequate lubrication can.
2, double-check all the fasteners are fully tightened.
3, carefully check the drive belt is good, if found to have broken the phenomenon, should be replaced. When there is oil on the belt or pulley, sweeping movements cloth to wipe application.
4. Check whether the ore crushing cavity or debris. Once there are ore or debris must be cleaned to ensure that the crusher load starting.
5, check whether the return from the top bolt, gasket if pressed, whether the T-bolts tightened.
Second, start
1, the inspection certificate for each part of the machine normal before starting.
2, crushers only allowed in the case of no load start.
3, prior notice must be starting with a bell or signal.
4, after the start, when irregularities are found, should immediately stop. After the identification and removal of irregularities before starting (non-starter with Yi Chang case).
Third, the use
1, the crusher before feeding after operating normally.
2, the materials should be crushed evenly added the crushing cavity. Avoid side added or filled with feed, so as not to overload caused by uneven discharge and undue mechanical damage.
3, under normal operating conditions, bearing temperature should not exceed 30 degrees, the maximum temperature not exceeding 70 degrees. When exceeding the temperature, it should stop immediately, identify the cause and to be discharged only after the starter motor.
4, the crusher before stopping, you should first stop feeding until after the crushing cavity material is fully discharged before turn off the motor.
5, when broken, as a result of the crushing cavity material obstruction caused by parking, should be immediately stopped, after the material is discharged, before re-starting.
6, one end fixed and movable jaw plate wear and tear, you can turn around and use.
7, crusher in use for some time, should be tight elbow sleeve again tightened to prevent loosening tight elbow sleeve machine damaged.
Fourth, lubricating
1, the regular attention and timely manner friction and lubrication work to ensure the normal operation of the machine and extend the life of the equipment.
2, the machine used grease should be based on the place of use, which conditions determine, under normal circumstances the use of calcium-based, sodium and calcium Kea grease.
3, added to the bearing grease is about 50% where the space volume, every 3 to 6 months to replace one, apply oil change clean gasoline or kerosene cleaning roller bearing raceways.
4, before starting the crusher, should inject the right amount of grease between the bracket and the bracket.
 Shandong Shengya Machinery Co., Ltd. has been committed cement products machinery development, production and sales, with advanced equipment, superb technical expertise and two decades of experience, the company has always been at the forefront of research and development center block molding machine market development , concerned about the advanced technology at home and abroad, to develop products for different investment needs of users, mainly block making machine, hydraulic tile machine, cement pipe machine, mixer, hanging roller machine, telephone poles machine equipment. At present the country with 19 offices and eight foreign branch (Nigeria, Tanzania, Algeria, Kenya, Ethiopia, Cameroon, DRC, Cote d'Ivoire) and exported to more than 100 countries and regions.